Titanium VTEC Killer Lock Pin Kit for Honda B Series H Series B16 B18C GSR
Fitment was pretty good, paired this exhaust up with k series Jackspania sidewinder turbo kit on rsx. Used a blox racing turn down muffler since the Jackspania one was way to long. I also used 3” vbands on this 3” exhaust, no complaints with this kit!
Had some slight fitment issues with the two exhaust flanges not lining up with the studs on the block, was able to force it with the flex pipes to make it fit, the over pipe and everything else fit fine. Make sure to grab a 14mm crows foot to tighten the passenger side header flange.
Great product , fits perfectly, all the necessary hardware is included. Shipping was fast and communication is great. Super happy with the product and transaction.
Installation was perfect for me took me no more than an hour to install for my rsx and they sound amazing
Easy to assemble, band clamps could be better. Sounds good, not too loud. I have noticed more people wanting to rev bomb me since I installed it.
T4 Turbo Manifold Inlet Flange Gasket Twinscroll Divided 304 Stainless Steel
Been looking around for a pair of ducted headlights for EG for sometime so I have an idea of what’s available. These offered by Jackspania Racing are the best value for money. It’s a solid 3D print with an LED projector and a DRL strip (with optional indicator wire) and you get both LH and RH lights.
The free shipping was super fast and well packaged to prevent any potential damage. My only recommendation is to dab some threadlocker on the bolts and nuts as some assembly is required and there was no instructions but it’s easy to figure out.
Also there’s no slot for the indicator to slide into for those EG models which interlock the indicator and headlight.
Overall very satisfied with the purchase being a first time Customer.
Honestly not bad, fits where it supposed to be, I even added vbands and I am not a welder by trade. This piping welded up fine paired with a turn down muffler from a competitor.
Great quality on all the parts. The shifter fit great with clearance everywhere. I have a k swapped civic. The rubber part to seal the outside from the inside on the shifter cables was fully in the way so I had to remove it. Also you can use an rsx base plate it just doesn’t light up great. Also the black plastic retainers needed some sanding to fit. After I installed it the shifter feels great. I have a 2010 accord transmission and it works even though it says it won’t. I would recommend getting the whole kit when you buy it.
Feels great. Shifts are short and crisp. Build quality is top tier for the price. Only problem is the bottom piece was too big for the shifter linkage. Reverse lock-out collar car rattle at certain RPMs but isn’t too big of a concern. If you’re reading this you should buy this shifter!
Besides the ebay one never had another donut gasket before this felt good quality and was a perfect fit hopefully I remember what size I bought.
Exhaust looks great and is nice and light. Easy install on the MK 6 GTI. Only concern I have is the clamps for the pipe connections. I had to crank them down ALOT with a 1/2 inch drive to get them to snug up and stop rotating. I felt like i was going to break the bolt in the clamps. I am letting it get through a couple warm up and cool down cycles and i will try and snug them again. Will most likely have it welded in the near future for piece of mind.
K20 K24 K Series Transmission Bracket EG EK Integra DC2 CRX K Swap Hatch Type S
Sounds great can feel the difference only complaint would be fitment exhaust hanger does not line up with factory exhaust hanger did also have to remove the subframe dampener
Great easy installation and I noticed a difference in performance! Smooth sounds and craftsmanship! I have been wanting these for a while now and decided to make the purchase. No regrets so far.
Love these turbos, have bought a few, make the same power as the genuine garrets too. But I'm sick of buying a t3 turbo, to toss the t3 housings and buy a vband entry housing. Hopefully JSR will include a option for vband entry housings at a slight additional cost after they see this 🫣
Easy to install and good quality
Almost 2 years strong with it. Worth it. Makes my turbo sounds like turbine love it
I received exactly what was shown in the ad.
Love it sounds great fit awesome as well